Shooting Bench Plans

Assembly - Step 2



Here's a cross-section of the leg mount showing the two different sizes of screws.

NOTE: If you decide to use 3/4 inch ply instead of 1 inch ply, you'll have to either grind the points off the screws after they poke through the table top, or use screws 1/4 inch shorter.








AERO ACES is a TRADEMARK of Michael A. Morrow.
All Images, drawings, plans, articles, and kits, are Registered & Copyrighted by Michael A. Morrow

These pages created and maintained by Michael A. Morrow - Copyright 1999 Michael A. Morrow.