Qty    Material

    (1)    28" x 36" x 1" plywood
               (I used 3/4 inch on the original
	 - 1 inch will work better).
    (3)    1 & 1/4" floor flange, galvanized
    (3)    1 & 1/4" x 30" galvanized pipe, threaded both ends.
               (when you get these pipes, make sure
               they have the plastic protective caps on
               the ends.)  Be VERY CAREFUL when
               handling the pipes - the threads are SHARP!
    (3)   screw-on galvanized metal end caps for the pipes
    (1)    1" x 4 1/2" x 24" Oak - get this bit in the
	finished lumber section of the hardware.
	This is actually more than you need, but
	you need the extra length to clamp into
	your vice.  Actual cross-section size is
	about 15/16" x 4 3/8".
    (6)    2" x 1/4" diameter wood screws with
		countersunk heads
    (6)    1 1/2" x 1/4" diameter wood screws with
		countersunk heads